Recent content by hvrtaxi

Alexandria, VA. Chinook and Cascade in large pots. . Cascade did far better. Last year I thought I lost them during summer vacation coinciding with a heat wave. So I cut them back in sadness. They came back and produced almost a pound by October! Lesson learned: don't neglect watering but...

https://www.homebrewtalk.com/f51/kegerator-conversion-danby-440bl-294606/ Not to hijack, but I had grand plans for my door but I ended up putting in a piece of plexiglass from a box store and it was fine. For my fridge, once the seal screws were out the interior fridge plastic came right...

Full bodied beer, full bodied hair...that basement tub is a true miracle!

NB Grand Cru partial mash. After a year and a month this is what it looked like: Pulling the lid off the fermenter was like pulling a saddle of a horse....awesome. Taste was light and lemony sour.

I'm in for the next round as well. Please add the following: 1 - BD-MOPA 1 - TF-MOPA 1 - GB-PALE Not sure if you are doing other individual items but I'd also like to add an 8lb PBW (5S‐PBW8LB) if possible. If not, I'll just work with you at pick up for what you have on hand...

Request post or PM for pickup location address in Takoma Park.

I know very little but I rehydrate to ensure those little friends are still kicking around. Probably outdated these days unless you are buying from a dusty old brew shop I'm a little cautious simply because I lost a batch due to weak (liquid) yeast and I cried when I poured it put on the lawn...

Please add me to the list for ... 1 - GW-PALE 1 - FB-PILS 1 - TF-MOPA Thanks!

This answer may be a buzzkill, sorry! When I used the 1/6th keg I borrowed a sankey tap coupler from my neighbor. He bought the coupler from the local homebrew store (and i think it was a standard coupler). Because I had still not cut off one of the standard beer line fittings that came with...

Thanks for the positive responses. I'll add a few more tidbits to this because I have pretty much finished my build. Additionally, I have an answer to one question that I could not locate on any forum. First things first, here's the finished build (Apfelwein and NB Oatmeal Stout on tap!)...

The holesaw I ended up using was pretty darn small, smaller than the 2.5"-3" recommended. I think it was 1-5/8" but I can't locate the darn thing to confirm for you. [It was the largest hole saw in one of those super drill accessory kits]. As I mentioned using a wood hole saw was less than...

22437

Gas line exits to the rear.

Double gas fitting the exit to the rear after a 90 degree turn.

Double tower.