Recent content by hater

They are all pin locks with the lids replaced for pressure relief. Pin locks are shorter but have a larger diameter than balls so it will fit 6 of either. Good Luck!

When i need to switch out that keg i do need to take the one in front of it out due to that fan.

Nope the lid has the thick plastic/rubber seal, but no hump. Mine sits flush and has good seal.

There are different opinions on this, but for a home setup the 10' lines seem perfect. I get next to no extra foam between the 10' lines and the recirculating fan along with good insulation.

Sorry for the late reply, I just realized all my emails from the list were ending up in my spam box. I like it a lot, after some trial and error i found that immersing the probe in 1/2 a gallon of water is about the right volume so i get smooth temperature cycles. I am on for about 20 minutes...

Sorry for the late reply, I just realized all my emails from the list were ending up in my spam box. The inner collar is flush with the freezer and is 8" high. The outer is 10" high so it hangs 2" over the freezer, this helps with the insulation but was mainly done to lock the collar in place...

Thanks! The CO2 lines are 3' each and the beer lines are 10' each. I have the beer lines zip tied in a loop to make them a little more managable.

I put this together starting with info i found on Homebrew Academy and modified it using info from the forums here, reddit and some other research. Freezer: 10.6 cu Igloo FRF1050 chest freezer painted black with epoxy based appliance paint Taps: 6 Perlick 630SS stainless faucets and shanks with...

I use a stainless table myself, I felt a lot better about the quality from the web restaurant store table then I did the one on amazon. I had the legs cut down 11" also. I have no complaints about the table, it works great. I move between indoor and outdoor brewing for the winter/summer and it...

I've been buying my hops here. They have great prices and ive been using them for a year now. http://www.farmhousebrewingsupply.com/1-lb-bags/

I've been fermenting my all grain Hefeweizen using 3068 at a constant 71 degrees intentionally to bring out banana and they have been producing an awesome banana flavor. Using a basic single infusion at 153 On my 1st generation of washed 3068 at the moment and it tastes as great with just as...

I was just kegging Oberon and secondary transferring the 2 hearted today. They tasted about right without carbonation... as much as you can tell at least. I shall report back in a week after I tap the Oberon

I had my Oberon go from an OG of 1.056 to a FG of 1.08. My 2 Hearted inspired beer went from 1.062 to a gravity of 1.09 when I transferred to dry hop after 12 days. Both were fermented controlled at 68

I used a 1200ml starter at 1.030. It worked great and got more than enough yeast to split 3 ways. I made another starter then and pitched that last weekend and it had my 1.054 batch going strong in 12 hours.

I successfully harvested yeast from Oberon 2 weeks ago, they use the same yeast as 2 hearted from what i have read. You will probably have better luck harvesting from Oberon since it was just released 2 weeks ago and has pretty fresh yeast. I took the last ounce or so from a 6 pack and a...