Recent content by Guinjasp

I am using a GC4 Grainfather Glycol chiller and conical fermenter and have an error symbol when starting up. From what I've read its low glycol /water. Can't understand why this would be as I put in 4 litres of water and 2 litres of glycol as per the instructions. Any ideas?

You should be able to find one on somewhere like Amazon or at an electronics store like Newark or Mouser. 3 pin male to 3 pin female molded cord set. Get the shielded cable version and the desired length you want( doesn't have to be same as the factory grainfather length) Gauge of the wire 22awg...

I have done a few batches and have put both rum (kracken black & Appleton Amber) and bourbon(makers mark) into a sealed jam jar with enough liquid to cover most of the spiral. I really haven't been concerned with the volume but ensuring that the liquid soaks the spirals evenly. Usually will...

I am a fairly new brewer and have been experimenting with medium oak spirals rum and bourbon soaked on a few batches. My latest venture is an imperial stout that I will be adding spirals that have been soaking in Makers Mark for over a year. My goal is a big beer that is thick chewy and boozy. A...

Yes I did take an OG reading so hopefully the fermentation is all complete and I will drop the temperature and let it clear. Might be going back to my fermzilla next time so I can see whats happening and can be sure of no leaks

Good to know Jambop will remember that on my next batch

Picked up a SS brew tech fermenter and keg fridge to better control temperature. Added an inkbird ITC 308 wifi controller and thought it would definitely improve my results. I tried my first brew using an S-04 yeast in a blonde ale dialed in my inkbird for 65 F as per the recipe recommendation...

Anyone using the Eadydenns Hydrometer? Thinking of it for our micro brewery and would like to hear anyones thoughts. I noticed there is a version 2 out now. Whats the difference?

So we decided to go back to Fotek as the footprint allows to bolt in the relay right into the heat sink. We discussed and purchased directly from a local Fotek distributor. Thought I would share the picture of old vs new. Lesson learned buyer beware when you buy off Amazon. You can see the...

Hi RufusBrewer yes they were all installed on a heat sink and there is a cooling fan also. I did read something about an epoxy that you should put between the relay and heatsink which I will probably do also.

Thanks Passedpawn. Will look these over for sure. Fotek Taiwan did respond asking for more information. Will let you know their response. I also reached out to the local distributor of Fotek for replacement pricing and insight. Perhaps they make a good quality product but are the victims of...

Yes I am looking at Crydom Opto22 and Carlo Gavazzi. Done with Amazon crap that could burn my brewery down

Hi Dtashmore yes these are mounted on a heat sink and we have a small fan installed. Just puzzling. I wrote an email to Fostek asking for an explanation and will share their response if I hear back.

It could have burned my brewery down amazon stand behind these and weed out these imposters.

Thanks gents. Going to replace them all now.