I'm working on building my own as well. So far it has been a lot of fun. And if you're near a hackerspace, there are a lot of people there who would probably really enjoy helping you out.
Yeah, that's a little big for 120V.
Good to hear that there's hope left for fixing my leak! Luckily it's just a test bucket. I'm going to have another go at it this weekend. I'll post with an update.
The heating element is 1500W. Also, the o-ring is on the outside of the can, per...
Planning on a small EBIAB setup with a 120V control panel. I'm still not quite sure how well 120V will do with 1 gallon batches. I'll have to boil 2 gallons. But I figure it's worth a shot.
You're right to connect your transformer to the Power terminals. However, the timer doesn't place any voltage across the contacts. Use terminals 4&5 as a 12VDC supply and connect the contact in series with the solenoid. Check out this picture of an SSR as a reference. Remember though, you're...
I'm working on a design to do small batch brewing with a 120V supply and heating element. Started the process with a test pot I bought from Salvation Army. Good thing. I have a leak and I'm almost certain it's because the punch hole is too large for the o ring. In general though, I had a...