The heating goes on the right side or Lo Stage switch with the same wiring configuration. There should never be any wires connected to blue b/c that's the switch's off position; voltage from your hot lead is routed to blue when the thermostat reaches desired temperature and power is cut from the...
(note that I've only wired the Hi-Stage in this picture)
The Neutral doesn't have to be cut, but I did in my build of it; you're using the neutral only to complete the circuit. Ground can also be left intact, but I split mine and grounded the circuit both to the chassis and back to the outlet...
Hi all,
I just recently purchased a JC A28AA-36 Two-Stage Thermostat and am having trouble getting started. I've seen tutorials on how to wire the Ranco Two-Stages but they don't seem very similar.
Here are the links to a picture of the the Manual and the actual device.
Picture of JC...
Hi all,
I just recently purchased a JC A28AA-36 Two-Stage Thermostat and am having trouble getting started. I've seen tutorials on how to wire the Ranco Two-Stages but they don't seem very similar.
Here are the links to a picture of the the Manual and the actual device.
Picture of JC...