Recent content by DirtyBurd

My fear is that it runs on low voltage (see wire colors) and that I blew it out by running 120 to it.

My fear is that it runs on low voltage (see wire colors) and that I blew it out by runing 120 to it.

I have this fridge : http://www.applianceaid.com/pictools/gefridge2.pdf I assumed the "tactile" board was was the touch control wires because after I wired everything up it doesn't work any more (doesn't light up). I haven't tested voltage or continuity because I ran out of time last night...

@cas3439 It turns out my wiring is a little different. I hadn't noticed until after I had wired everything and made my cuts in the door. I knew the controls were different but assumed that if wired like @kgmac311 with settings set all the up to 9 it should work the same. Turned it on...

Rough Draft

So there are 2 relays in the mix now? Can you post a picture or 2 of where and how you mounted them. It would be helpful to see them wired in on one of the diagrams too as I'm struggling to wrap my head around it. I just bought my fridge yesterday, almost identical to yours. I'm super...

Noobe here, I think the fridge I'm looking at has the same main control board but I'm terrible at this. GE model: GSS25SGPE from what I can tell uses PN WR55X10942 control board. Is this the same as in your build? If it is I can mirror your wiring and save an epic amount of time and a...