Recent content by Dellboy78

Thanks, no I hadn’t. I’ve switched it back off and done a reboot. There is a slight change….but I’m still only getting not quite 3 of the 6 taps displayed on the screen, and still got the white stripe down the right hand side.

It was set to ‘ON’ I turned it off to see if it made a difference but it doesn’t seem to have done anything.

So, I re-entered these settings at the bottom of the config file and rebooted the pi. They are definitely doing something now, but the image is now huge and only a section of it is displaying. Any ideas?🤷‍♂️

Thanks for taking the time to reply, I have done this (I think) but haven’t noticed any change to the screen when I reboot the pi. I am a complete beginner with this so have probably done something wrong. Could I have entered the settings in the wrong place of the config.txt file?

I have just run through the installation of raspberry pints. When the box came up to choose monitor size, the size for the screen I am using wasn’t an option so I chose the closest one to see what would happen…. Now I have a white stripe down the right hand side of the screen and the bottom of...

Not heard of a brownout before! What does that mean? I think I just bought a power supply on Amazon. My pi is mounted on the pack of the screen and is fed from the screen itself via a usb.....

Yes, I think I will have to start over. Just need to remember how I did it the first time now! Thanks.

I don’t think so. At first I thought my screen was faulty as it was black and occasionally flashing white. I’ve not seen a screensaver as such come up.

I started my keezer build last summer and in anticipation bought myself a raspberry pi and a screen and installed raspberry pints, which seemed to work fine on its test run. Roll on to now and the keezer is finally working, but my raspberry pints doesn’t seem to be playing ball now I actually...

Ah, great, thanks! Only just seen this for some reason! I’m quite tempted to try these. I did email them to see if they could give me any more info, but I’ve not had a reply yet!

Top man, thanks

Ok, I will attempt this...first, as raspberry pints automatically loads up when I switch the pi on, how do I get back out to the home page to open a terminal etc. (Like I said a total beginner at this!)

Apologies if this has already been asked. I am an absolute beginner at this, but have just installed Raspberry Pints on my pi. Have changed the background image but it would be handy if I could alter the font colour of the writing so it shows up a bit better against the new background. Is this...

Hi, would you recommend these flow meters? I’m trying to find something suitable that’s not as pricey as the Swiss flow ones!