Recent content by Dave77

I bottled 2 batches of beer today. An Amber Ale and a Cream Ale. Getting set for patio season!

I just rinse the bottles a few times immediately after pouring, and turn them upside down to dry before storing them away. When I bottle I just give them a quick rinse, then a shot of Starsan, and that's it. Maybe I am not thorough enough, but I've never had a problem with contamination...

Thanks everyone for contributing to this thread. It helped me in my decision to finally pull the trigger and order one. Can't wait to try it out! Have been a BIAB brewer since I started.

Don't worry about it - that's normal. It's just the CO2 burning your nose!

Both places are great, but I tend to go to the Guelph store - I actually live in Georgetown (I wrote Toronto in my profile because nobody outside of Ontario would know where that is!), but I hate driving into Toronto so I usually go to KJ Brewing Supplies in Guelph. Great staff, and if you...

Welcome to the forum! And yes, hopefully I can help you out as a fellow Ontario brewer. https://torontobrewing.ca/ - is definitely really good and very well supplied. If you're close, their retail store is worth a visit. Craft Brewing - I've also ordered a lot from these guys. Their...

Just an update on this condundrum in case this thread is searched in the future with the same problem. I just sampled the finished beer, and it is really quite good. No harm, no foul. I screwed up the dry hop, but good beer emerged nonetheless!

ready for deicing

Hmm. Well, if there is no obvious leaks, you're probably fine. I have had this situation before as well when I just couldn't figure out why there were no bubbles, but the beers turned out fine. Sometimes fermentation just has a mind of its own! LOL

I think the Brewer's Best kits assume you won't be going out to buy extra equipment (bags) for this, so you should be fine to just add the spice directly.

I just had a similar situation - no bubbles, but things seemed to be happening. Then I noticed there wasn't that much water in the airlock, which meant the C02 was likely releasing without showing any bubbles. I filled the airlock to the proper level and alas, there were bubbles! Not sure if...