Recent content by Chris1272

The picture links in this thread were dead for some time. They are now updated to on site hosting and should be good now. Also Update: Kegerator is still going strong and faithfully serving beer.

here it is all done with kegs tucked away in their new home.

The first test pour of warm flat beer... Tastes like success.

Here I am tightening the bolts from up under. I found out you need longer bolts than what come with the tap so this is right after an unplanned midnight run to wally world for some 2 1/2 in #10 bolts and washers.

Im making marks for drilling pilot holes for securing the tap.

Here is a top down view. with waterproof tape lining the hole to keep moisture out of the exposed insulation.

Measure twice cut once and drink home brew while your work... I think thats how it goes. anyway Im making measurements and reference points to center the tap tower.

The two Cornelius kegs and CO2 canister and manifold that will be going in the fridge.

Here I'm using a hole saw to drill through the top of the unit for the tubing. It is very slow going when cutting through the metal top.

I removed the plastic door piece, and had a piece of plywood cut to the same dimensions. after spray painting it white I replaced the rubber boarder and installed it in the door.

Turning a Danby refrigerator into a 2 tap kegerator.

Good people is a good place, and I've heard good good things about Avondale. The best beer bar in town in The J Clyde. There is no such thing as a brew put in the state of Alabama but there are tap rooms at the breweries in town.

Last time I was in ABQ I had a very good experience at the marble brew pub.

personally I would pitch the 3711 when you rack. keep in mind that It is aggressive and will ferment you beer very dry.