Recent content by cacm2226

That makes sense. Thank you.

If Im adding all required salts and gypsum to the MLT strike water, what is to happen with the fly sparge water that will be coming in from the HLT which is untreated? Will adding the total amounts of salt and gypsum (mash and sparge) to just the the strike water in the MLT throw anything off?

Hello to all, Planning on a brew session and will be treating my water. My question or dilemma is, I EHERMs brew with a 20 gallon HLT. The brew recipe has me treating the mash and sparge waters separately which is fine, except when it comes to fly sparging I will be drawing water from the HLT...

Irrelevant because the reading and correction will be made during mash if any?

Hey all, I'm looking for a good profile for a medium body blonde ale. I was going to use the yellow beer medium body in beer smith 3 but it's showing a pH of 8........ does that even sound right? I'd would rather use a good one that has a pH that sounds correct. Chris

I should have phrased the question better, what is your alkaline wash set up?

Thank you.

What is a alkaline brewery wash SOP?

I believe it came out to about $230. It was a custom build from Utah bio diesel which is the same as arbor fab. The size was to fit a bayou classic 15 gal kettle. I also ordered a press plate for it as well as a U-bar support to be used with the basket hooks to support it above the kettle.

I just received my custom boil in a basket from Utah bio diesel. It needs to be cleaned and sanitized. What is the best process for this? Thanks in advance. Chris

Finally getting brew day in after almost 2 years....

Thank you for the heads up

Ok

Is it still for sale?

PM me, I don't see the ability to PM you.