I'm approaching my first conical carb then pressure transfer so I'm planning out what I actually need to make this work. Should I stick with 3/16" ID or does the ID matter for a transfer?
Thanks for the input! I ran another test transfer with one unit on the kitchen counter, the pump on the floor, and three feet of supply-side hose. It seemed to work a bit better as I was able to lift the water back up to counter height and into the sink through seven feet of hose on the other...
I need some clarification on what the optimal position of a Riptide pump (or any pump like it) should be relative to my liquid source and destination.
I know the pump needs to be below the source but by how far? Is there a general rule of thumb I can use to have the optimal height and length of...
I really appreciate the information in this thread and others. I am basically ready to purchase either the Spike Conical of the SSB Unitank, however I've never seen either one in person, know how they look and feel "live", plus I'm not sure that any one of the major differences (i.e. ability to...
I haven't tried it your way (I'd like to) and I'm pretty new to kegging. Because I don't have the equipment volume to be transferring beer between multiple containers after fermentation, I've simply added gelatin directly to the serving keg (after chilling for 24 hours or so) and have been...