Recent content by billfloyd806

Keg fits perfectly HMI graphs temperature of keg over 24 hours Allows the operator to adjust the temperature and view all the alarm set points and alarm values. Control is done by a DL-06 PLC Monitor the tower temperature and adjust the set point. Alarm screen...

Keg fits perfectly HMI graphs temperature of keg over 24 hours Allows the operator to adjust the temperature and view all the alarm set points and alarm values. Control is done by a DL-06 PLC Monitor the tower temperature and adjust the set point. Alarm screen...

Keg fits perfectly HMI graphs temperature of keg over 24 hours Allows the operator to adjust the temperature and view all the alarm set points and alarm values. Control is done by a DL-06 PLC Monitor the tower temperature and adjust the set point. Alarm screen...

Keg fits perfectly HMI graphs temperature of keg over 24 hours Allows the operator to adjust the temperature and view all the alarm set points and alarm values. Control is done by a DL-06 PLC Monitor the tower temperature and adjust the set point. Alarm screen...

Keg fits perfectly HMI graphs temperature of keg over 24 hours Allows the operator to adjust the temperature and view all the alarm set points and alarm values. Control is done by a DL-06 PLC Monitor the tower temperature and adjust the set point. Alarm screen...

Keg fits perfectly HMI graphs temperature of keg over 24 hours Allows the operator to adjust the temperature and view all the alarm set points and alarm values. Control is done by a DL-06 PLC Monitor the tower temperature and adjust the set point. Alarm screen...

Keg fits perfectly HMI graphs temperature of keg over 24 hours Allows the operator to adjust the temperature and view all the alarm set points and alarm values. Control is done by a DL-06 PLC Monitor the tower temperature and adjust the set point. Alarm screen...

Keg fits perfectly HMI graphs temperature of keg over 24 hours Allows the operator to adjust the temperature and view all the alarm set points and alarm values. Control is done by a DL-06 PLC Monitor the tower temperature and adjust the set point. Alarm screen...

Look at a Honeywell 7800 flame safety relay. You might have to use a generator as well to supply 110vac for the control system, but you could use a ultra-violet peeper for LP. I have built a lot of control systems using to monitor the flame on a tube burner up to 4,000,000 btu. You can change...

I'm showing a 220vac model is yours is 110vac just wire the same way.

I guess I should have also asked what are you hooking it up too? Kegerator cooler?

Look over the photo and see if that will get you going. I show no heating and cooling connected to a single outlet. Just remember attach the hot wires to the copper colored screws and use a pair of snips to cut the jumper out between the two copper screws. This will allow one side to hot and the...

http://www.automationdirect.com/adc/Shopping/Catalog/Sensors_-z-_Encoders/Temperature_Sensors_-a-_Transmitters/Thermocouple_Sensors/Probes_(with_Attached_Plug)

Looking great!

I'm in the process of trying to determine the amount of beer left in my keg as well. I purchased a turbine flow sensor (see link) and connected it to my control system. I'm currently running trials with water and I'm very impressed with the accuracy so far. I talked to tech support before...