Recent content by BC2

bump

Howdy Folks, I'm just about done wrapping up a 20 gal. single tier 100% Stainless steel system that I was building for a friend. He decided to go in a different direction, so I wanted to post this to see if anyone in the Tri-state area might be interested in it. The features include...

Correction: it is 240v. With a single 4k element that would put it at 16.6 amps. Is this an acceptable draw on a 20a breaker?

Thanks for the reply Cevan Would a 4k or 4500w work under 20 amps? He is not concerned with reaching boiling temps fast because he has many other tasks that would be taking place during pilot brews.

Howdy folks, I know these types of questions get pounded into the ground everyday, but I have had a little trouble figuring out a solution to my newest project. I have been fabricating simple brutus type systems for a while now, but up until now they have all been simple, manual gas...

Brewvall: When and where did you use the honeysuckle? And did its flavor/aroma really make it to the finished beer? I've been thinking of using it in a beer. thanks!

Hi all, Went to Birreria on the rooftop of Eataly last weekend and was really impressed with the setup. I noticed they only served their house beers via hand pump. I was assuming they chose to carbonate this way due to lack of space for a brite tank possibly? Regardless, the beers...

Hi All, I was trying to find some info on this but had no luck. I want to grow a couple hop plants indoors this winter (NJ) as an art project. It would be part of my MFA thesis that basically is a small brewery start to finish. I am not really worried about yield, just exhibiting the plant...

After a long night I made the mistake of taking a reading before topping off my carboy with about a gallon of water. My OG reading was 1.076, can anyone tell me approximately what it should be around after being diluted? Travis

Does anyone know where to find this label paper? I am thinking along the lines of a heavier letterpress paper. Thanks Travis