Recent content by Arod_3

Control Products and Johnson are two different companies. The reason you can't change the setpoint below 0 or above 100 is because you need to change your High and Low Limits (HSL and LSL) in the controller. The limits allow you to basically "Lock out" the controller so nobody can walk up...

I'd love to figure this out! Anybody know where I can get something like that for cheap?:mug:

I did something similar with my controller. I have my probe in a small jug of water in the cooler. The temp in the cooler may change a couple degrees with a differential of -2. But the brew isn't going to realize this temp. So if you have a set point of 72 with -2 differential, your ambient...

I went to their website and got a diagram. After talking to person at Control Products I got mine up and running. So far it has worked perfectly. go here for the diagram, http://www.controlproductsonline.com/9102-series-temperature-controllers-p-103-l-en.html Message me if you questions...

Go to the link below. I had to do the same thing with this controller. Let me know if you need. http://www.controlproductsonline.com/9102-series-temperature-controllers-p-103-l-en.html

Emailed support: Yes you can extend the (sensor) wire up to 100(feet) before starting to lose calibration. The units have plus and minus 30 degrees of calibration to compensate for longer sensor lead lengths. Any 18 to 26 gauge wire is fine.