Recent content by Andrewk311

Got everything finalized including the element lamp and ran a wet test last night. Works awesome. Thanks again for all your help!!!

For the neutral lead to the firing lamp, I can tie in on any neutral post correct? Just because it would make life easier, I can tie the neutral into #10 on the EZBOIL?

There isn't any issue with substituting the LED firing lamp with a 120v neon lamp is there? I found one at a local shop for like 3 bucks

Man you must really know your stuff! Should be a simple fix too. I'll rewire that part tomorrow after work. Thanks man!!

It's the LED inside the switch, I didn't put an element firing lamp in.

Hey man no problem at all! I think I can use it as is, it only does that bad sound when the element switch is on first. If I switch main power first it seems to work fine. Thank you though! Let me know. Also wanted to tell you my fiancés territory for work is the northwest and I ride alone with...

Sweet, thanks! It seems like the interlock works as intended but for some reason makes that noise if power is switched on after the element is switched on. I will be able to test and see if the element actually won't heat while the main power is off this weekend.

Wiring done! I still have to finish some loose ends and clean up the wires with some zip ties but I fired it up and seems to work great....with the exception of a few things First, the LED for the heating element comes on when switched, even if the main power to the box is off....does this mean...

I noticed today, my blue LED switch is for 240 V service. I'm pretty positive that the website did not have a choice for 120 or 240… Will this not be compatible with my set up?

Got everything fit, wiring tonight.

The cabinet was set up with the ground lugs, so I just attach all ground to those two, as well as SSR mounting bolt?

That ground that runs to the SSR on the diagram...there isn't a terminal for it, can it terminate on the post on the enclosure wall?

Sweet. Thank you!!! There is a hole cut for the heat sink that I have to modify a bit, I was just checking for aesthetic reasons. This is so cool I'm getting to work. Thanks!!!!!

Also, my SSR has a heat sink that came with it. Is it necessary to mount this outside the enclosure? Or would it be safe to mount it inside, on the DIN rail? I have no clue how much heat a SSR will actually generate

If you could show that on the diagram that would be awesome! I somewhat figured out how the interlock works, mainly because the hot wire in only goes to certain components. I will probably end up buying an additional bus terminal for all the neutral lines because I don't think I can fit that...