What did you use for fittings?? I'm assuming this spins when liquid is pushed through it.. I'm looking to make one just like this and I'm trying to find the fittings to use.
M
MNBugeater
I replied in your post also, but it is just a tee fitting and swivel union. The size will depend on what size pipe threads you need to adapt to. I believe mine are 1/2" but you can use what ever you want. This should get you close...
12-16" of 3/8" Copper [Depending on mash tun size] - Cut in half
3/8" Copper Tee
3/8" - 1/2" FPT
1/2" x 1/2" MPT Swivel Union
