WTB: 1" Stainless Steel locknuts, matching silicone o rings, and gang boxes

[runningweird]

I am going to set up an electric kettle and HLT and was wondering if anyone out there had a couple extra locknuts with o ring grooves to hold the camco 5500 element in place.

I also need the silicone o rings that fit into the locknut grooves, the 2 gang boxes and their lids.

I know I can order them from retailers but I thought someone on here might have some sitting around


Thanks

 

[mikeysab]

Mind if I ask if you're following instructions, or just throwing it together?

 

[runningweird]

The plan - which is forever changing with gained knowledge and is as follows:

cut hole in keg, solder locknut onto keg - fit gang box on somehow(need to buy a dremel tool)

wire
profit?

I am following stuff from the electric brewery, and some other builds in the electric brewing section.

Control panel will be a PWM controlled BK at first - eventually a HLT and pump.