BigCatBrewery
Well-Known Member
Anyone ever seen these before? More specifically, anyone ever sized them for a new o-ring?
Wierd dlotted pressure relief valves
- Thread starter BigCatBrewery
- Start date
Help Support Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum:
What did that come off of? It sure doesn't look like any kind of PRV...
Cheers!
Cheers!
OP
OP
BigCatBrewery
Well-Known Member
From 2 used ball locks I just purchased.
Ah - I see.
I'm pretty sure what you have is the moral and functional equivalent of a metal slug stuck in a fuse socket: it won't work as what it replaced.
You could get actual replacement PRV valves for those kegs...
Cheers!
I'm pretty sure what you have is the moral and functional equivalent of a metal slug stuck in a fuse socket: it won't work as what it replaced.
You could get actual replacement PRV valves for those kegs...
Cheers!
OP
OP
BigCatBrewery
Well-Known Member
Seems like the posts would make that difficult. Or would the key ring style do the job?
OP
OP
BigCatBrewery
Well-Known Member
I have one of those on the way. Here's hoping!
Got three kegs (one without lid) for $60 off CL, so I'm not opposed to a little more investment.
Got three kegs (one without lid) for $60 off CL, so I'm not opposed to a little more investment.
OP
OP
BigCatBrewery
Well-Known Member
Just to put a bow on this thread for any searching with similar lids: the replacement PRV did not fit. It did not screw down far enough. But poppet o-rings did fit the slotted posts pictured above, and now both work nicely as a hand tight, screw style PRV.
Similar threads
