HellBentBrewCo
Well-Known Member
I'm building my control panel and I'd like to use the lighted push botton switches I see all over the place here. Where is everyone purchasing theirs from?
Why do people put a switch for the alarm? I figured all of that would be PID controlled?
There is no way to turn the alarm off from the PID (at least the Auber PIDs)
To disable the alarm when you do not want it to go off. For example if I set an alarm for right before boiling temperature, to make sure I am there to lower the manual mode output and prevent a boil over, the alarm will continue to go off throughout the boil because the temperature is still above the high alarm. There is no way to turn the alarm off from the PID (at least the Auber PIDs) so a switch is wired between the alarm relay and the buzzer.
iijakii said:Thank you. I had no idea you couldn't enable and disable the alarm from the PID. You can only set the parameters for when it will go off?
iijakii said:Debating on putting an alarm on my build now or not. I can see where it'd be useful, being able to set an alarm and walk off. But at the same time, don't think I'd really use it. Might look cool though
Enter your email address to join: