dochawk
Well-Known Member
- Joined
- Apr 1, 2020
- Messages
- 63
- Reaction score
- 20
I found some threads in the archives, but none that got to the end.
The refrigerator is a 2000 GE (I measured to make sure it would fit 4 cornies in the main compartment and 2 in the freezer before buying for my wife back then . . .).
The interior is 18"x18", and it would be the mounted shelf (not the cantilevered shelves).
My attempted measurement of the glass with a tape measure says 1/8" (can't find my calipers at the moment)--but none of the calculators out there go below 3/16".
It appears that it should only bear the weight of one or two kegs (or 20 lb co2 tank).
Is anyone successfully mounting more than that long term?
I guess it's not too big a deal to cut an 18x18 piece of another board, but if I can avoid it . . .
The refrigerator is a 2000 GE (I measured to make sure it would fit 4 cornies in the main compartment and 2 in the freezer before buying for my wife back then . . .).
The interior is 18"x18", and it would be the mounted shelf (not the cantilevered shelves).
My attempted measurement of the glass with a tape measure says 1/8" (can't find my calipers at the moment)--but none of the calculators out there go below 3/16".
It appears that it should only bear the weight of one or two kegs (or 20 lb co2 tank).
Is anyone successfully mounting more than that long term?
I guess it's not too big a deal to cut an 18x18 piece of another board, but if I can avoid it . . .