TiltPI and CraftbeerBI3 in the same raspberrypi

HomeBrewTalk.com - Beer, Wine, Mead, & Cider Brewing Discussion Community.

Help Support Homebrew Talk:

Marcelo Medeiros

New Member
Nov 20, 2019
Reaction score
Hi Guys,
Hope you're all fine.
I am noob in raspberry. However, I already could setup a craftbeerpi and/or Tiltpi in my raspberry (3+) independently.

What I am trying to do is to run both (craftbeer and tilt) in the same raspberry.

Any of you did this?

Here what I got so far, please let me know if I did something wrong, or if I should do something different:
1. I have the tiltpi running fine
2. have installed the craft beerpi
3. have installed the pyton3 (the tiltpi uses 2.7 and the craftbeerpi3 uses 3)

Tilt is OK up and running, but I got the below "status active (exited)" in the craftbeer.

Any help would be very much appreciated.

[email protected]:~/craftbeerpi3 $ sudo /etc/init.d/craftbeerpiboot status
● craftbeerpiboot.service - LSB: Put a short description of the service here
Loaded: loaded (/etc/init.d/craftbeerpiboot; generated)
Active: active (exited) since Mon 2020-02-17 22:57:27 NZDT; 9min ago
Docs: man:systemd-sysv-generator(8)
Process: 17519 ExecStart=/etc/init.d/craftbeerpiboot start (code=exited, status=0/SUCCESS)

Feb 17 22:57:27 tiltpi systemd[1]: Starting LSB: Put a short description of the service here...
Feb 17 22:57:27 tiltpi craftbeerpiboot[17519]: Starting system CraftBeerPI daemon:.
Feb 17 22:57:27 tiltpi systemd[1]: Started LSB: Put a short description of the service here.