Quantcast

Taprite Secondary Dimensions?

HomeBrewTalk.com - Beer, Wine, Mead, & Cider Brewing Discussion Community.

Help Support Homebrew Talk:

mtmeyer32

Member
Joined
Sep 8, 2011
Messages
13
Reaction score
0
Location
Macon
Can someone who has a Taprite wall mount secondary like this pretty please take some measurements for me. I need to know how far they stick out from the wall after mounting and how wide they are. Or if someone knows where this information is that would be awesome! I can't find any dimensional drawings on Taprite's site.

Thanks for any replies!... my jester ripoff number 1,495 is underway. Im cash committed now so no turning back haha. Will post pics soon.
 

beaksnbeer

Well-Known Member
Lifetime Supporter
Joined
May 4, 2011
Messages
2,855
Reaction score
517
Location
New Port Richey
I don't use the stand-offs. But the 4 3/4 is the min. The with will depend on the length of the nipple. I use close nipples on the set I built I have 9 total with the first used to carb/condition on a 4 block splitter. I would guess that 2 inch nipple, so 10- 12 inches........my.02 good luck
 
OP
mtmeyer32

mtmeyer32

Member
Joined
Sep 8, 2011
Messages
13
Reaction score
0
Location
Macon
Thanks for the info beaksnbeer, but I am a little confused...if you could maybe tell me in terms of H,W,D in this pic that would help me. I am mainly concerned with the Depth. From the wall to the top of the control nobs. Thanks again.

TapriteDimen.jpeg
 
Top