SS table brewstand conversion

[two_hearted]

I recently picked up this SS table at an auction and was thinking about using it as a brew stand. Basically, my new keggles won't fit on my turkey fryer.

Any advice on how to attach a couple propane burners to this? Anyone done something like this before?

 

[microbusbrewery]

In my opinion, the only thing that kind of sucks with this kind of setup is the height. I used to use a stainless table/cart I got from Sam's Club and I felt like I was always peeking over the top of my MT. It's doable, but not as convenient as a custom-built stand. Does the top lift off? If so I'd consider trimming 6+ inches off the legs.

As for mounting burners, there are a few examples on HBT, and some of these might solve the height issue.
https://www.homebrewtalk.com/f51/stainless-sink-table-brew-stand-226158/
https://www.homebrewtalk.com/f51/st...ble-brew-stand-278439/index2.html#post3846620

 

[ibbones]

. Basically, my new keggles won't fit on my turkey fryer.

I had the same problem so I went to the big box store and bought a Webber replacement grill and set it on top of my burner and it gives ma an inch lip all around. Just make sure whatever type of grate is bigger than your keggle.

 

[two_hearted]

In my opinion, the only thing that kind of sucks with this kind of setup is the height. I used to use a stainless table/cart I got from Sam's Club and I felt like I was always peeking over the top of my MT. It's doable, but not as convenient as a custom-built stand. Does the top lift off? If so I'd consider trimming 6+ inches off the legs.

As for mounting burners, there are a few examples on HBT, and some of these might solve the height issue.
https://www.homebrewtalk.com/f51/stainless-sink-table-brew-stand-226158/
https://www.homebrewtalk.com/f51/st...ble-brew-stand-278439/index2.html#post3846620

Nice, thanks. Now i just need to figure out how to weld... or work around that.

I had the same problem so I went to the big box store and bought a Webber replacement grill and set it on top of my burner and it gives ma an inch lip all around. Just make sure whatever type of grate is bigger than your keggle.

Great idea. I have 2 of those in my garage right now!