Removing Stick-em safely

[Gnome]

Using copper for manifold in MLT, It has stick-em on it from the bar code labels. What can I use to get it off safely? Will goof off or a similar solvent leave a residue? Boil? Any suggestions.

 

[SuperiorBrew]

It should be ok as long as you wash it off with some ozy or PBW when your done

 

[Gnome]

Thanks, I tried Alcohol and soaking in Star san. Still there. Trying to avoid off flavors.

 

[5 Is Not Enough]

I'd try a hair dryer/(distant)torch followed by solvent for the adhesive.

 

[raceskier]

Goo Gone is a little slow, but will safely remove about any kind of label gunk.

 

[CodeRage]

WD-40 does an AMAZING job of removing stickies. Spray it, let it soke for a couple seconds and then hit it with a paper towel.

 

[mrk305]

zippo lighter fluid... it evaporates in a few seconds

 

[Gnome]

Thanks guys. Star san soak overnight took care of most everything. Boy, dose that copper look good, really bright and shinny.