So I've had quite a few issues with my Keg Connection setup so far. I finally finished my Keezer and mounted my regulators to the collar. I hooked up the gas, pressure on the dials rises fine, hooked up the gas line to a keg, opened the valve on the regulator to pressurize a soda keg, and right around 28-30 PSI, the needle starts rattling like wild back and forth. The odd darn thing is that if I close off the valve on the regulator and then reopen it, the rattling stops on the needle and dosn't come back... It's so odd! I'm assuming this isn't normal???
Regulator Dial Rattling...
- Thread starter horric29
- Start date
Help Support Homebrew Talk:
Sounds like a loose diaphram. If you are comfortable with working on a regulator (which means you can purchase a new one if you break the old one), I would suggest a rebuild. If you remove the pressure adjustment assembly, you will find a little usually brass screw in the middle of the diaphram. Tighten that down and you should be good to go after reassembling the regulator of course.
