Hello all. I received a new kegerator for a birthday gift and am in the process of setting it up. I’m stuck on a few things and any advice would be greatly appreciated!
-the co2 and beer line that was included is marked as 5 mm ID and 8 mm OD. Most fittings that I have seen are listed in customary units. 3/16, 1/4, 3/8, etc. are any of these compatible with the hose I have?
-looking to add some inline quick connects between the tap and keg so that I can switch from ball lock to sanke. Has anyone successfully done this? Any advice on where to purchase. Most of the beer sites are asking $15 a set and I know that they can be found for 1/2 that on other industrial sites.
-the co2 and beer line that was included is marked as 5 mm ID and 8 mm OD. Most fittings that I have seen are listed in customary units. 3/16, 1/4, 3/8, etc. are any of these compatible with the hose I have?
-looking to add some inline quick connects between the tap and keg so that I can switch from ball lock to sanke. Has anyone successfully done this? Any advice on where to purchase. Most of the beer sites are asking $15 a set and I know that they can be found for 1/2 that on other industrial sites.