I just set up my MM2 and hooked up my cordless Dewlat drill to it. I don't intend to use the cordless permenantly. I can see the roller moving but when I add grain, the roller stops moving. This is just 2 row grain. I upped the speed of the drill with no success. Best I can tell, the shaft stops turning and no matter how I tighten the drill, it stops turning the roller when grain is dumped in. I was testing about an ounce at a time.
I checked to be sure the chuck teeth were on the flat ends of the shaft to avoid slipping and there's no damage or wear on the shaft thus far. I haven't messed with gaps because MM says to use it at factory first, which I am.
I feel this is obvious, but I'm missing it big time.
I checked to be sure the chuck teeth were on the flat ends of the shaft to avoid slipping and there's no damage or wear on the shaft thus far. I haven't messed with gaps because MM says to use it at factory first, which I am.
I feel this is obvious, but I'm missing it big time.