Mike-H
Well-Known Member
Ok, so I found a source for kegs and I am going to make an AG system for doing 10 gallons over the winter..... By looking at the pictures, it looks like the top keg is keg + spigot + thermometer and so is the bottom keg (i'm going to use a cooler for the sparge/lauder)... Couple easy questions:
Do you HAVE to weld the spigot in? Link to good spigots?
Do you HAVE to weld the thermometer in? Link to thermometer?
* by HAVE to I mean, is there any weldless things I can use? I have all the means to cut & drill stainless but I would rather not rely in a welder, however, I dont want to sacrifice quality.
Is that all I need is a spigot & thermometer?
Where should those 2 be mounted I.E. therm, 10 inches above bottom, spigot 1 inch above bottom?
I am under the impression I just need a thermometer and spigot, if i'm way off base, tell me to f - off and RTFM.
Do you HAVE to weld the spigot in? Link to good spigots?
Do you HAVE to weld the thermometer in? Link to thermometer?
* by HAVE to I mean, is there any weldless things I can use? I have all the means to cut & drill stainless but I would rather not rely in a welder, however, I dont want to sacrifice quality.
Is that all I need is a spigot & thermometer?
Where should those 2 be mounted I.E. therm, 10 inches above bottom, spigot 1 inch above bottom?
I am under the impression I just need a thermometer and spigot, if i'm way off base, tell me to f - off and RTFM.
