Faucet and shank assembly

[jcs401]

So I took apart my faucet and shank assembly to put new Bev-seal line on my tower and keg system. I have one of the curved gooseneck shanks. When trying to re assemble I got it all set and now for some reason I cannot get it tight to where it will stop moving. Is it the nut on the inside of the tower that I need to get tighter or would it be the faucet to shank connection? Pain in the ass! Is there any video anyone knows of to assemble this to make sure I have it right??


Sent from my iPhone using Home Brew

 

[BobBailey]

Same setup as my tower. I found that turning the entire shank/faucet about 1/8 turn CCW, hand tighten the nut and then hold the nut while turning the shank/faucet back works well.