So basically, the face that reads psi (in the tank, not serving pressure) on my dual-gauge regulator is curling up, causing the needle to become stuck in the "red" zone. Is there a way to take the face plate off the regulator so I can try to bend the dial-face back to normal (Im assuming it's probably metal instead of cardboard, though Im not really sure). I removed the 2 screw on the back, but it still cannot access the internal part. This brand is called "The Governor" if it helps......
Dial-face on regulator is bent........
- Thread starter Old_Raspy
- Start date
Help Support Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum:
Remove the gauge from the regulator, remove the bezel or clear plastic cover, remove the screws and then the housing should slip off the gauge so that you can see the dial and the mechanism. It's probably easier to simply replace the gauge, but it is possible to somewhat straighten the dial.
Similar threads
