lostforatime
Well-Known Member
I have been trying to figure out where I should cut the hole for the shank. The front or side? Does anyone have pro's or con's to either.
Cuttin the hole today!
- Thread starter lostforatime
- Start date
Help Support Homebrew Talk:
Putting the taps in the front means the hoses are in the way every time you open the door. It also means they are easier to get at for cleaning. Plus, on small fridges, you KNOW there aren't any cooling pipes in the door.
What david_42 said.
If you choose side, it may be in a bad place if you move.
I can't think of a situation where that woud occur on the door.
The metal on fridges are surppisingly thin. Some sealant, sheetmetal and insulation will cover any abandoned holes.
Or you can use a big ass bolt like this...
If you choose side, it may be in a bad place if you move.
I can't think of a situation where that woud occur on the door.
The metal on fridges are surppisingly thin. Some sealant, sheetmetal and insulation will cover any abandoned holes.
Or you can use a big ass bolt like this...
If you choose the door and you have a top mount freezer, you're going to have to plan for tap heighth.
