Can't find a manifold fitting

Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum

Help Support Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Falcor

Well-Known Member
Joined
Jun 25, 2009
Messages
73
Reaction score
1
Location
Chesapeake, VA
So I'm trying to build FlyGuy's MLT, but I went with 1/2" CPVC instead of the braid. I've run into a bit of a problem though, I can't find a fitting that will connect the 3/8" brass pipe nipple to the 1/2" CPVC. I've checked lowe's, home depot, and the internet but haven't come up with anything. I know this piece must exist because other people here have talked about the CPVC manifold. Any suggestions?
 
I decided to try lowes again one more time. This time I looked in the copper section also and found the perfect fitting. 3/8" female threaded on one end and 1/2" push on the other and the CPVC fits just right.
 
Back
Top