user 302314
Active Member
- Joined
- May 24, 2022
- Messages
- 27
- Reaction score
- 4
Hey All, I completed my first brew last night in my BrewZilla (which was a blast and I learned a lot). In BrewFather I notice two different suggestions for water levels and I don't really understand how to interpret it correctly.
My recipe shows a Pre-Boil Volume of 14.46L
And in the water section, it shows Total Water of 16.06L
My thoughts were my total water is my Pre-Boil volume of 14.46L brought up to strike temp, then run off my sparge water from that. But then I would be under the suggested mash water volume.
It's left me a little confused. Perhaps someone here may be able to offer direction?
My recipe shows a Pre-Boil Volume of 14.46L
And in the water section, it shows Total Water of 16.06L
My thoughts were my total water is my Pre-Boil volume of 14.46L brought up to strike temp, then run off my sparge water from that. But then I would be under the suggested mash water volume.
It's left me a little confused. Perhaps someone here may be able to offer direction?