i have the bottle wand attached to my bottle bucket spigot via small piece of racking tube. the problem is when I go to turn the spigot on the water (test run) only goes to the wand then stops. If i push the middle part of the wand i get some flow but also a lot of air. how do you pros do it?
Bottle Wand
- Thread starter Jmwoody
- Start date
Help Support Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum:
The wand has a little valve at the bottom that is intended to be depressed when it hits the bottom of a bottle. It makes for a less messy, less tedious bottling session than if you had to mess with the spigot for each bottle. The air should quickly purge when you fill the first bottle.
That's why we're here! Good luck with your bottling!
