Been planning my keezer setup to be MFL all the way, from the primaries up to the tail pieces. Absolutely paranoid about leaks. As a result, upsized to 1/4" barbs on the 3/16" Bev-Seal for extra protection, and will also clamp.
The problem is, 3/8" barb to 1/4" MFL swivel nuts for the 5/16" gas lines aren't carried everywhere. My three choices seem to be:
1- Order everything from a vendor that does carry them, and eat the extra cost.
2- Order 5/16" barb to 1/4" MFL swivel nuts and deal with the paranoia.
3- Order 1/4" gas line and 5/16" barbs, losing the nice color differentiation between wet and dry lines.
Anybody care to argue for one in particular?
The problem is, 3/8" barb to 1/4" MFL swivel nuts for the 5/16" gas lines aren't carried everywhere. My three choices seem to be:
1- Order everything from a vendor that does carry them, and eat the extra cost.
2- Order 5/16" barb to 1/4" MFL swivel nuts and deal with the paranoia.
3- Order 1/4" gas line and 5/16" barbs, losing the nice color differentiation between wet and dry lines.
Anybody care to argue for one in particular?