Would make a good small kettle chiller or pre-chiller for someone. Is about 14.5" tall, diameter of a corny. There is one kink/dented area at the bend of one of the spouts, but the flow rate is still just fine. It can always be cut off and a compression fitting put in if it bothers you. I can also cut the straight pieces off (roughly 1.5ft) and send just the rounded coil. Let me know what you'd like.
Looking for about $10, PM me an offer. I can check the shipping for you first, but it's ~7 in central US, and ~10 to coasts.
Looking for about $10, PM me an offer. I can check the shipping for you first, but it's ~7 in central US, and ~10 to coasts.