1in od X 1/2 ID threaded stainless coupler?

[kickflip_mj]

I have been looking for this for a while and cant seem to find one, anyone know where I can get one?

 

[501irishred]

Will probably need two pieces like a 1"x 1/2" bell reducer and a 1" close nipple. (This would give you 1/2" female threads and 1" male threads)


Sent from my iPad using Home Brew

 

[GotPushrods]

1in od X 1/2 ID threaded stainless coupler?

Are you just talking about the OD of a regular 1/2" stainless coupler being 1"? I'm guessing not, since those are sold everywhere. I've used many, and the OD is usually more like 1 1/32". You could turn one down if this is what you're after.

Or do you want 1" male NPT threads on the outside, and 1/2" female NPT on the inside?

 

[kickflip_mj]

Are you just talking about the OD of a regular stainless coupler being 1". I'm guessing not, since those are sold everywhere. I've used many, and the OD is usually more like 1 1/32". You could turn one down if this is what you're after.

Or do you want 1" NTP threads on the outside, and 1/2" NTP on the inside?

Shoot I guess that would work perfect, I guess I was making the assumption that they where actually 3/4 OD. I am looking for a 1/2 coupler that has around a 1 in OD.

 

[501irishred]

What's your application ? Might help with coming up with alternate ideas.....


Sent from my iPad using Home Brew

 

[BigFloppy]

it's called a bushing

 

[Stealthcruiser]

Look in here.

http://www.mcmaster.com/#standard-metal-pipe-bushings/=r2wotu

 

[kickflip_mj]

Sorry guys I ment 1/2 threaded on the inside, smooth 1 welding coupler on the outside. After doing some research, I learned that most couplers are 1 inch on the outside.

 

[mattd2]

Nevermid then

 

[kickflip_mj]

Nevermid then

Haha thank you anyways. For some reason I kept thinking they were 7/8.

 

[GotPushrods]

Shoot I guess that would work perfect, I guess I was making the assumption that they where actually 3/4 OD. I am looking for a 1/2 coupler that has around a 1 in OD.

Heh..no worries. That makes more sense. I only know this since I always measure each one before pulling my dimpling tool. I've used quite a few from different places and they are pretty consistently just over 1".

Is this for your rig?

 

[Bobby_M]

My 1/2" NPT full and half couplings measure exactly 1.063" OD. It depends on the brand, but a few other manufacturers are slightly larger for their 150# fittings.