1/4" MPT to MPT Shut Off Valve

[jackers252]

Does anyone know where I can get some? I am making some gas manifolds for a keezer project and would like to connect two of these, two gang manifolds, yet make it so I can isolate each manifold when needed.

This is the closest I have found:

 

[Catt22]

A 1/4" ball valve and 2 NPT nipples would do it. Most valves have female threads. The valve you have pictured appears one of the shut off valves with a built in check valve designed for use on a CO2 regulator. The male NPT X male NPT valve will be hard to find. I've never seen one, but I cannot say for certain that they don't exist.

 

[bad coffee]

http://www.harborfreight.com/brass-air-inline-regulator-32905.html

IDK if it actually goes the whole way off.

Do you have a part number for the blue splitter you posted? I can't seem to find it on the site anymore.

B

 

[jackers252]

It is an in-store pickup only item.
http://www.harborfreight.com/2-in-1-air-manifold-93979.html

 

[jackers252]

I actually found the ball valve (at all places) Amazon.
http://www.amazon.com/dp/B003K3TEGK/?tag=skimlinks_replacement-20

 

[jackers252]

And now I actually found that manifold on Amazon, too.
http://www.amazon.com/dp/B001TXQ0TM/?tag=skimlinks_replacement-20