1/2" TC x 3/8" barb

[rkovatch]

I have a BL214 Blichmann 14 Gallon Fermenator Conical (Tri-Clover Fittings).

It came with a 1/2"x1/2" fitting for the dip-tube/bottling output. I would like to use the smaller bottling wand right from the barbed end. I have been doubling up on tubing to make a not very efficient reduction on the bottling wand.

Do you know if I can get a fitting that will fit on the 1/2" clover fitting, but have a 3/8" OD barbed fitting instead? I want to use a 5/16" bottling wand.

or

Does anyone have another idea?



Thanks in advance for the help.

 

[FireManDan]

Nor Cal Brewing Solutions would more than likely be able to do this up for you.

http://www.norcalbrewingsolutions.com/store/Hardware-Tri-Clover-Solutions.html

 

[rkovatch]

Thanks for the suggestion FireManDan. I didn't see it on the website, but I sent them an email to make sure.

 

[bruce_the_loon]

You could get a 1/2" tri-clover with a 1/2" NPT female and then a 1/2" NPT male to 3/8" barb if you can't find a single adapter.

 

[rkovatch]

I think that is what I will have to do. I like the larger output when I was kegging, but I am down to bottling for the time being. Thanks for the help.