Search results

Loading like peons stopped many rears ago:D:D. All done with air.

Not as shiny as the hop dispenser from Die Beerery but way older than him.:ban:

I use wave sounds to give verbal instructions, warnings etc.

I use wave sounds to give verbal instructions, warnings etc.

I use wave sounds to give verbal instructions, warnings etc.

Going with BC is the way to go if just starting, saves you some money. I did my PLC project 20 years ago and started with an IDEC which was quick replaced with Automation Direct controllers. Now I am running a few PLCs which communicate with each other through power line Ethernet adapters plus...

His SSR controller works different. According to the Mypin manual the SSR alarm out supplies 24VDC +/- 2V

Will this work, not DIN. Only $ 10.89. https://www.ebay.com/itm/0-56-PT100-Thermometer-200-450-Digital-display-LED-Temperature-Sensor-red/192767567106?hash=item2ce1d7a502:g:FCAAAOSwHGJcHqLD&frcectupt=true

I have been using an low priced open ultrasonic sensor for a few years in my cold water supply tank plus flow meters . The sensor is used during automatic filling the mash tuns only, water removed on command from the PLC. Since mine is not enclosed it needs to be replaced between 18-24 months...

I installed a trap door more than ten years ago to combat the steam from popping up the hops in the first tube.. A solenoid opens and closes the door as required.

Great job. Shouldn't read full auto minus hop and grain additions?

I use the low foaming Sani Clean from the same maker in my setup with five gallon containers filled with three gallons max.

Here are two pictures what I use to monitor my CO2. The unit has different program parameters to control the outputs. I use it to monitor CO2 loss in the distribution system,, turns the CO2 delivery system off in case of loss. This unit will work for your application too, set the pressure limit...

Search for Johnson Controls Electronic Pressure Control

It's a 24 VDC, 1.8 RPM motor. Solenoid protective housing 24 VDC tubular solenoid, 3 kg pull force (depends on your requirement.) Similar to this ebay version...

In this old picture it is the black wire.:D:D

I use an air amplifier for grain transport from the mill, 30 foot run.

Steam will effect the hops and makes them expend inside the tube. I installed a solenoid with a trapdoor to prevent steam going up. A few old pics. My set up is running for years now.

Looks great!! I miss wire numbers;)

I do like Automation Direct PLCs, easy to use. I started in 1995 with an IDEC but was too limited. I never liked Allen Bradley and local support in 1995 was very costly.