Search results

Aervoid model 801 - 5 gal - $250 Tomlinson - 5 gallon - $150 PM if interested or need more information/pictures. Will consider offers for one or both. Both made in the USA.

PM sent for HLT.

Can I see a picture of the guts of the control panel?

I would move the valve on the wort pump to your germs inlet and put a 3 way in its place. It will make your transition to boil kettle seamless. Then don’t disconnect and save losses for when you whirlpool and then when done whirlpooling use same 3 way to push to your plate chiller. I’m rocking a...

Is this 110v or 220?

Any issues with condensation on the inside? Did it have a lip? Pics of you don’t mind. I think the foam was my #2 choice for the interim.

Has anyone used an old 3 compartment stainless sink as a vent hood with some modifications obviously? Wondering if this would be a good cheap long term solution or if I should fab something else from scratch. Only drawback I can see at the moment is no good condensation lip on the inside. Cost...

You may be right. I knew it was a stretch for this forum, and will likely put it up on probrewer. I would let it go for $600. Its not really in the way at the moment so no desperation, and is still on the potential for adding some fittings to it to increase the value. I'll continue to sit on...

Bump. Any interest at all?

that makes two of us on the PMs

I’m considering putting a temp controller and a valve for a counterflow chiller. Wanted to see if anyone had done anything like this yet? May not go to the length of a temp controller but will definitely have a switch on my panel for chiller water. Any valve suggestions or setup suggestions...

Pictures Please.

Bump still for sale, debating adding some welded triclamp fittings to it.

Pm sent.

I guess we’re in auction mode now.

Pm sent

Bump

I have a large ~120 gallon tank in fair condition. Before I put too much work into adding triclamps or other fittings, making it a true beer brewing kettle, I wanted to see if there was any interest. I am wanting $750 OBO. I haven't cleaned it since it was obtained from a family member who had...

Buyers beware of this Seller. He has had money for over 1 month and have lost contact. Have not received parts or my money back.

I'm putting a herms coil in my HLT and wanted to know how high front the bottom I needed to drill the element hole. I'm stepping towards a e-herms but am starting with manual propane at this point so won't be drilling the element hole yet I just want to plan for it. It's going on a 15 gal G1...