Search results

bump

I think it would be awfuly expensive, but I'll look int it

bump

sold

I'm selling my stainless vent hood with a 6" blower it's 24wx48lx14h $300 pick up in PA 18403 Thanks

Only pic I have now, I'll get anothe when I get home

It is bare bones as I said. No lid, just pot with holes punched.

bump

Shipping is $38

d

Sold

I have a brand new in box 20 gallon Boilermaker that was sent to me as a replacement. It is the pot only, holes are factory punched for the sightglass, valve and brewmometer. No lid $200 plus shipping or pick up in PA. 18403 Thanks This is a G1

Don't need much space, I have it under my front porch, about 5x15 area

I've made the hard decision to downsize, as I just don't have the time with work and family to brew as much as I did. It is too nice a system to sit idle in my basement. Just need a 30 amp power supply and it’s ready! I built this Kal Clone myself and it has operated flawlessly for the past two...

I just wanted to share my experience with Blichmann today. I decided to brew an orange wheat last Saturday, on my Kal clone electric setup. I filled my HLT with 20gal water and in about 10 minutes I noticed the table was wet?? I wiped it up and sure enough in 10 min, more water.... I tilted...

I'm in

I make starters all the time with old yeast, my LHBS sell outdated yeast for $3 each. I Start with a 2l starter on my stir plate, sometimes it takes a week to take off, after that I cold crash, decant and pitch into a 5l starter. in another week or so it is a huge yeast cake ready to go. I have...

Great article, thanks

Great article, thanks

Yes, line up one of the chuck "teeth" with the flat on the shaft and tighten. if needed file another flat on the shaft inline with anothe teeth on the chuck