Search results

http://newyork.craigslist.org/lgi/spo/2109343923.html Saw this on CL today. I have no need for it so I am posting it for you guys. Seems like its a standard corny keg plus the added portable gear. A hundred buck seems steep, but I am sure you can negotiate.

Your winter jacket and two towels are wrapped around your mash tun while you are freezing your @$$ off in a sweatshirt.

Over the years (2) my brew system has taken many forms. From my mothers kitchen, the backyard and more recently the driveway. A more permanent, space saving and low cost solution was needed. Behold the Collapsible Wall Mounted Three Tier Brew Stand for Preservation of Time and Space...

This Sunday I am brewing a Belgian IPA with some modifications. Credit goes out to Barry at Craft Brew Advocate.com who helped me with the recipe. Grain Bill: 8lb Pale Malt 3lb Pilsner .25lb carapils .5lb Munich Malt .5lb White Wheat .25lb Honey Malt Boil Additions: 1oz...

Like many before me I purchased a Johnson A419 24v and tried to juice it up with 120V. After the smoked cleared I opened it up to see that two resistors were blown ans possibly a capacitor (circled). Assuming all the other components still work I should be able to clean it up and solder in the...

Not mine saw this online.

Hey HBT need some advice. Ive been brewing for a little over a year now and I am looking to cut costs where I can. I understand that breweries have "house strains" that they recycle over and over again. As I have the capabilities for both ale and lagers, what general strains would allow me...

http://newyork.craigslist.org/mnh/for/1987037346.html Not mine. I emailed the person, but changed my mind so up for grabs.

All brewers strive to shave time off of their brew day. I am wondering if any brewers use hot water from their house tank to mash and sparge the grains. This would save loads of time as the water is already very close to mashing temp.

The biggest hurdle are the rollers. I propose the following. The rollers will be cast from cement!!! A 10 inch by 3 inch diameter pvc pipe will be fitted with a 3 inch to .5 inch reducer an each end (see pic below) and and have a .5 inch threaded rod centered in the two fittings. Once the form...

Here is the final result. The bottling crown is bolted to a piece of electrical conduit.