Search results

Wow, how can you tell its not really well bonded? Is there something in the pic that clues you to this? I ask because, like I said before, it was my first time soldering SS, so I need to know what to look for in a good joint. BTW, did I mention no leaks? As to the MAPP gas issue. I understand...

Hey guys, I just tried brazing SS for the first time. Like many of you I'm pretty anal about what touches my wort so I researched Brewmoor's suggestion of Saft-Silv 56% silver solder. This stuff is NSF meaning it is safe to use on food product and it works great. I used a plain Bernzomatic...

Where might I find someone to powdercoat my frame when constructed? Where did you get the components for your electronics set-up?

Mine were just as bad when I picked 'em up. I cut out the top using a similar jig to Bobby's, then started with the coarse gator grit pads and worked down to fine. Bobby has pointed out that the coarse and even the medium pads may be too abrasive. I'm sure you can knock out all of that stuff...

Hey Bobby, thanks for the info. Went to Lowes to get the course, medium, and fine pads. used all three, then use the buffing pad by gator grit and used the black emory. Didn't bother the use the green rouge cause I saw the swirl marks. I'm not going over that again, but what can I do for next...

This may be a stupid question as someone may have already asked, but I could not find: Would it be possible to run several lines with valve lines through just one pump, or would that be inefficient? i.e. 4 valve lines leading in to pump and 3 lines leading out. Curious to your response.