Search results

That upgrades don't end.

Once you attach a hose to the mash tun, you have in essense a movable hole. Just keep the end of the hose lower than the bottom of your mashtun.

you could buy a cheap porta-band (portable band saw) at harbor freight.

I don't like it either.

5/8" tubing should be the same size as 1/2" copper pipe. You can use 1/2" fittings.

i drill all my holes. Easier for me than cutting slots. i drill holes with a 3/32" drill bit..

I ordered rhizomes from them 2 years ago with no problems.

Just do not over water them if you plant them in a pot. Drowning them is the number 1 way yo kill them.

I don't even like mine. I should have just stuck with the cheap turkey fryer burner.

you can go on You-tube and look up grain mills. There is a bike powered mill on there somewhere.

put some duct tape on it if you wanna keep it ugly..

All my manifolds are CPVC pipe with holes drilled in them. I put the holes down. i never had a stuck sparge.

i made a couple oblong slots, wide enough for a hose clamp, in a piece of wood and mounted with 2- 4" hose clamps (worm clamps). 4" hose clamps fit pretty good around the pump.

you can also find heat exchangers on the internet( if you're looking to save money). i got mine from dudadiesal.

if you want to cut down on flying bits, you can just grind your grain at my house. hell, you can even brew your beer at my house..i will take more pictures next time.. mike

I always drill a couple of holes in the lid of a cooler and blow spray foam in it. one hole to blow foam into and one hole on other side for it to come out. there is no insulation in most cooler lids.

Put burners on top.