Search results

Does the valve on the right side have a 90 degree fitting on it? If that is the case then why not use that for "spin cycle" and remove the arm on the upper one completely? Then you could attach a Blichmann device such as what day_tripper suggests, I use a SS fire ring that I found on Amazon...

Appreciate the info. I will look at the bAST value that I am using.

Bobby, I appreciate your feedback. I guess I missed that the mOUT can use a duty cycle. My comment about the bOUT is still correct I believe. The DSPR does not allow you to set a boil temp I assume it is hard coded in @ 212, which for my area is not correct so when I run the boil program, I...

Bobby, how do I set the duty cycle then? I typically use the mash profile for boiling since it allows me to set a specific temp whereas in boil mode I could never find somewhere to set the temp, it just seemed to run the controller up to some invisible preset temperature. Any additional info...

I have only scorched wort during boil with fairly high starting gravities (1.07 and above). As I mentioned I believe it is due to the DSPR's inability to set a duty cycle and temp. You can set temp in mash mash mode or duty cycle in boil mode but not both. So in mash mode if I set my temp to...

Do you have an SSR in there?

My experience with the DSPR-320 has been mixed, with normal gravity brews it does fine, but almost every big brew 1.10 and higher I end up scorching the wort and ruining my heating element (not really ruined but it is covered in baked on black char). I bought a SYL-2352 a while ago as that is...

Belgian Dark Strong 15# Pils 5# Vienna 2.5# D180 ~ 12% ABV Electric heating element burnt it 🤬, went ahead and put it in the fermenter, will see how it tastes in a week or so, not very optimistic though.

Don't fear the foam!!!!

Nice, I will have to try that next time I see any build-up on my chiller coils.

Here is what I use for the exact same issue on those Spike coils 1) Rinse with water 2) Acid treatment: 50/50 mix of phosphoric/nitric acid rinse (~ 140F) for 15-30 minutes. 3) Alkaline clean: soak in 140F PBW (or other non-caustic alkaline cleaner) for 15-30 minutes 4) Rinse with RT water...

Could you shar the actual excel spreadsheet? I'm lazy :cool:

Not this people. :cool::barf:

What board are you using? Is it available on any site?

Is there a section in BrewPiLess that calls out Thorrax's(Thorrak's) code?

I use Visual Studio to upload/flash. What I am saying is that when I assign the pins that Thorrak uses for his new "all in one" board (OneWire data: 13, Heat: 25, Cool: 26), the program uploads fine, when I attempt to assign those pins to the relative functions (i.e. heat, cool, and...

Sorry, I have been trying multiple versions of your program (BPLGX, BPL 4.4, and 4.3) that screen shot of the Config.h is from 4.3 and the default_envs is as follows. default_envs = esp32, esp32-oled, esp8266, esp8266-oled, esp8266-glycol, esp8266-tw, esp8266-spanish, esp8266-portuguese-br...

the only active one is default_envs = ESP32_debug all the rest are commented out. Do I need to change that to a different setting?