Search results

Sorry, I created confusion here. It was tyler180 that had the metal grinding. I just had a non-parallel gap, off by 0.010 side to side. Blichmann support just got back to me. They found a spare plate that they said I can replace on my mill to get the gap parallel. Hopefully, this fixed the...

I'm hoping there's hope. They have responded, and said the mills do have an internal adjustment to make them parallel, they are searching for a spare piece for that adjustment. I brought this to their attention when I purchased the mill, and after a couple exchanges it came to the message...

Sorry to revive an old thread. Just curious what happened with your blichmann mill issue. I got one that has a 0.010 difference. Support said it wouldn’t matter. I’ve been battling inconsistent mash efficiency ever since. In discussions with them now.

Dang! You got some good zoom and eye balls! So....... I didn't realize the sanitary sample valve needed to be fully disassembled. While CIPing I opened and closed it several times and gunk came out. On the last batch, everything was disassembled, cleaned, boiled, cleaned again, and sanitized...

Thanks. We'll find out. I did three iterations with BKF and it removed nothing. Then did CIP with alkaline brewery wash at 140 F for 25 minutes followed by a 10 minute rinse at 165 F. Then disassembled everything including butterfly valves and cleaned with TSP, rinsed, boiled everything for 5...

Any update on how brews have turned out? I've been fighting infections for three months and am at my wits end. Stumbled upon this thread and now looking at my tank it has a similar flaw and was purchased around the same time as yours. It's not as pronounced as yours (photos below), but the same...