Search results

If the panel is your main panel, meaning it is the main disconnect for the dwelling, you will have the neutral and grounds bonded and using the same bus bar. This is normal, and to code. When you get to a subpanel, like the Spa panel mentioned, then you will need to have sperate neutral and...

Ordered up a G70, it has shipped. Very excited.

I grind my grains into a 5 gallon bucket. Heat my strike water. Then slowly pour the grains in. Then I use my comically large 24” whisk. Works great every time and not a lot of effort involved.

Yes, this. FRP is what's commonly used on the walls, etc, of commercial kitchens. It's not expensive.

I've got a ratcheting pulling. I can hoist my bag up the point where a couple inches of it is still in the wort in my kettle. So I lift it up and over a second pot we use for canning and squeeze the **** out it with high heat gloves on. Then just pour that into the kettle for the boil. That...

That's amazing to see!

Planning on brewing a light IPA, with Simcoe, Lemondrop, and Mosaic. I think the packet of yeast I pulled out of the fridge for the starter is dead though. Use by 12/4/20. Proper Starter can is fresh though. I have another. If it doesn't perk up, off to the LHBS!

I don't see any reason you can't use separate fermenters.

I've learned now that you can never have too many o-rings.

Heard back from Northern Brewer. Here's the details. AS568-014 SILICONE O-RING, -014 McMaster-Carr carries them, as well as most other places. An 014 size heat resistant silicone o-ring. The big set I have stops at 013, of course.

Thanks, I sent them an e-mail but haven't heard back. You'd think this would be listed right on the instruction sheet instead of just "2x O-rings".

Hi all, Went to do some cleaning on my 10 gal Megapot 1.2, and I noticed an O-ring had worn out inside the isoflow bulkhead. It's the one the diptube meets up with. Went through all my gaskets and don't seem to have any that fit properly. I'm sure someone here knows what size to use. My...

Awesome tool!

Did they boil water on that stove? Probably. I can't imagine it wouldn't be ok.

That's what I'm using. Two pieces on the kettle to attach the refelctix to. Then a strip on the reflectix itself so it stays put after it gets wrapped around the kettle.

Where?

Love my Avantco 3500. Using it with a 10 gallon MegaPot 1.2.

We stopped going to Brookeville when it turned into a day care center. We're at EP pretty regularly, prolly 3-4 times a month. Waredaca, which is right around the corner form EP is fantastic. We're there regularly too.

Looks like GO-Brew meets in Olney regularly at Brookeville. Haven't been to Brookeville in ages.

Dumb question. Is there a MoCo brew club? Should we start a MoCo brew club?