Search results

In

I currently have 4 of them...had 5 but like stated above, they're made out of really thin glass, and do break easily. Other then that, they are the cats meow, easy to clean, easy do steal small samples with a pipette for tasting/refract testing. And you dont need to use an airlock/stopper or...

Bill...or George...anything but Sue!

i8n

in

In Sent from my iPad using Home Brew

im in

Im in Sent from my iPhone using Home Brew

im in

Im still waiting for my other 2 taps to arrive... Sent from my iPhone using Home Brew

-Are your pumps mounted "upside down" to the underside of the table top? Yes -Do you have any priming issues with them not being much lower than the kettle drains? not really, but im probably going to install a T and a valve right after the pump, make priming easier. -Any priming or...

i need a dual guage co2 reg, or even a multi reg distributor. Or a 6 way distributor. also need some 2.5-3.5 inch shanks, and taps

1 - 5 gal glass carboy $30 1 - 6.5 glass carboy $35 Huron SD

yours SSR doesnt give a rats @$$ where the voltage signal is coming from. If its going to get any DC voltage 3vdc-32vdc, 3mA-32mA, its going to close the SSR allowing power to pass thru the SSR. So what has been mentioned a couple times in this forum, if you hook your DC+ right up to the SSR...

you can use the PID as a gate, and buy some AC in SSR's like those http://www.ebay.com/itm/1pcs-Solid-State-Relay-SSR-40-AA-AC-AC-40A-250V-80-250VAC-24-380VAC-/370724518373?pt=LH_DefaultDomain_0&hash=item5650e739e5 and just jump your neutral on your PID from Lug 9 or 10(whichever one is...

what SSRs do you have? DC or AC in? post the make/model

I dont know yet, in wintertime ill be brewing inside, so Ill hang on the wall, but Ill probably make some sort or a stand or something to mount it on for when im brewing in my garage, about 4 ft off the ground, with a slight backwards slant...

You could place your drain below the MT. But because the drain under the screen is only about 1/8 of an inch off the bottom of pot, it wouldn't make much difference . And when im sparging, i alway leave 1 inch water above grain bed. So really, i dont see a point in having the drain on bottom...

After yesterdays brew, I had to drill those holes out on my sparge hose because they plugged when I first started the HERMS circulating pump. I gotta figure something else out for a sparge unit. Yesterdays efficiency was 87.13% Not bad if you ask me, being that Im still fine tuning the system

Yes, those are 44qt bayou classic pots, the false bottoms I got from ebay http://www.ebay.com/itm/130900576545?ssPageName=STRK:MEWNX:IT&_trksid=p3984.m1439.l2649 And then I threw out the fittings and installed all 1/2 NPT and 5/8 barb so theres no flow restriction. As far as the measurement of...