Search results

Thanks a bunch. Fortunately, money isnt that big of an issue but I do want to get the best bang for my buck and figured I would look at all the available options. I know if I get the cooler system, I will want to upgrade in a year and wish I had just bought the other the first time. I thought...

I been brewing about 5 years now and havent made the leap to all grain just yet. I am going to make that leap really soon and have been looking for a setup that suits me. I dont really want the cooler systems as I know I will want to upgrade from that to soon. I would like to go all steel and...

I did put the tank in the fridge! Thanks a bunch. ben

I just got my first batch of CO2 and got my system hooked up. I think I may have a small leak somewhere but I can't find it. When I first hooked up the CO2, The pressure reading was at 900 and 3 hours later it had dropped to 800. I think the relief valves are fine, because I primed the kegs...

I have figured out why they sent the single regulator with the splitter. There are two seperate kits and I ordered the wrong one apparently. E8006 comes with one regulator and a splitter while E8004 comes with a dual regulator. Completely my fault, no fault of Midwest.

Well I recieve my equipment from midwest. I havent spoken to them yet but the brewlogic gas requlator I recieve is differtent than the one pictured on there website. The pictured one shows the ability to control two different keg pressures and a tank fill indicator and the one I recieved only...

Thanks guys. I pulled the seal back and saw that I could remove I was just nervous about doing so if it wasnt necessary. I wasn't sure if it would be to difficult to replace with wood. I hadn't even thought about the growing bacteria behind it because of a leak. great point. I think I...

I am preparing my fridge to convert it to a keggerator and I have a question about the plastic trays on the inside of the door. The part where I would like to put the taps has an egg holder there. Do i remove the whole plastic piece or should I just cut the egg holder portion off? I am...

I just purchased my stuff for a similar set up yesterday. I ended up going through midwest because I've used them since I started brewing and have always been treated really well. I researched it for a while and went ahead and went with the brewlogic Dual tap draft system from midwest...